The only way I could get my old 105 combine with a 4020 gas engine to not load up was to plug the passageway to the vacuum operated accelerator pump piston. The fuel economy went up too. The vacuum piston has no seals and gas starts sucking past it. There is gas on one side and manifold vacuum on the other side. Downfall to this is I had to open the throttle very slow or it just sat there and popped through the carb when I opened the throttle. Worked OK on a combine, won't work for a tractor where the load is varied so often.
I just read where Roberts Carb claims to have helped with this on the cast carbs. They claim all it takes is some machining and a viton seal. I wonder if they aren't talking about this accelerator pump piston. They claim Zenith has agreed to make the changes and manufacture them.
I forget if the 105 had aluminum or cast, I'll have to run down to the machine shed to have a look at the engine some day. I have a hunch it is cast.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.