Posted by showcrop on March 26, 2016 at 10:26:35 from (75.68.77.41):
In Reply to: Cost of bearing! posted by 4wdtom on March 26, 2016 at 08:13:17:
Yes, bearings are usually cheap, but there are plenty of odd ball bearings like the ones that allow a shaft to wobble a little, or have a slightly off dimension, that no doubt have much shorter production runs so set-up etc. per bearing is going to be higher. Inventorying anything odd ball means probably sitting on it for months if not years. Use of a bearing that is close, but not exact has consequences. My $13,000 snowmobile has a front axle bearing from the factory that has slightly too large an ID. Consequently the shaft turns in the inner race instead of the bearing turning. So in 5,000 miles the shaft is worn to where it has to be replaced.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.