Posted by wjkrostek on March 09, 2016 at 21:58:45 from (216.137.214.176):
In Reply to: Re: Frontier vs JD posted by David Snipes on March 09, 2016 at 20:54:30:
I did some checking on the web which I'm not good at. the frontier DM5070 a 9 ft disk mower has a weight of 1143lbs the JD 280 also a 9 ft disk mower has a weight of 1475 lbs. I assume they are the same. They look much the same. I have to believe the JD is a heaver frame material put the parts maybe the same. Does anyone know if the parts fit each other? The JD R280 list at $13,789 and the frontier DM5070 listed at $7,999 from the same dealer in the mid west. That's a big difference for 330 lbs of steel. That's a lot cheaper than I was quoted up here for the frontier and I don't see that JD was $9000. more than a frontier. Is there a standard amount you can expect them to dicker with you? like 10% off their asking price? I haven't checked yet but I should get it to Alaska for less than a $1000 then I'd have to put it together.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.