Posted by The tractor vet on February 25, 2016 at 18:09:49 from (104.179.81.68):
In Reply to: BIG MUSKIE posted by stonerock on February 25, 2016 at 13:31:34:
Yep, i have seen it up close and running . along with the other big ones . Hauled coal back in those days . I even worked in a strip mine for a short time running a 992 Cat loader . Started the coal hauling sorta part time with just loading a couple trucks on a Saturday' for a buddy that had seven trucks and sometimes the regular drivers were not up to go load on a Saturday . I was usually off since i was the boss at my day job . Started driving full time when i had enough of the day job . We hauled from the big mines down to the Ma and Pa mines . One little deep mine was run by a father and his two sons . They had a rickity old tipple that we could just get under and had to load from the back to the ft. so the weight would settle the truck down enough so we could get a decent load . When ya went to load you had to go back into the mine and find one of them to come out and load ya. So it was put on your coveralls put your rubber boots on and your hard hat with a Wheat lite and play hunch back for a mile and a half then try and figure out where they were down what shaft . About the same at the Copper head mine if ya had a problem ya had to go find someone and they were all back in the mine , There was a reason why they called it the copper head mine . That one was not as high as the father and son mine as they were in a four foot seam that went for miles . So if the loader did not start you did all you could to get it up and running before you did the hands and knees thing and found something blocking your way in or out.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
