As others have mentioned, if it's bent, you can straighten it to some degree, but it is not going to be as strong as it was pre-bend.
Given that it is a loader cylinder, it would pay you to get another rod made. Think, if it does bend and cause the loader bucket to collapse one sided, it will damage both cylinders, the boom, and the loader frame.
In other words a new rod will be much cheaper than the repairs necessary if it 'lets go'.
Ultimately, if it got bent, it did so for a reason. Just because a machine will pick up x amount of weight, doesn't necessarily mean it should...... You might want to lighten the load a bit all the time, or at least until you can get a new rod made.
A new rod can't cost that much. One and three quarter is a very common rod size, and sticks are available from places like McMaster Carr. From there is shouldn't take a machinist but an hour or two to machine one end to accept the piston, cut it to length, and weld the eye off the old shaft on to it. I just did one for a customer last week, and I had about 2 1/2 hours in the whole job, and that was having to modify the piston as well as machining the rod.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.