I have a couple stories about dogs and cats different from those already stated. First... A couple years ago we picked out a new kitten to replace old one that died. We only have one neighbor, a 6-4 burly guy that is a prison guard who loves cats. He is only at this house semi-occasionally when he comes to fish. Well when our new cat was about 6 to 8 months old the neighbor saw him in his yard, and thinking he was a stray, he took him when he returned to his full-time residence. And there he stayed for 3 weeks. When I asked him if he had seen our cat, he said no, however the cat mysteriously showed up back home the following weekend when he returned to fish. The cat was so well fed that he did not eat upon entering our house. We all laugh and say the he had gone on a "rumspringing"! Second... In my area of Southside Virginia it is custom to hunt deer with dogs. Hunters have legal right to enter your land to "retrieve" their dogs, (upon notification of the landowner.) Also several fox hound tournaments are held in this area. It is not unusual to have 200-300 hounds running across my pastures at 6AM. Some of these hounds are really dumb, having been kept in pens their entire life and when released they display really stupid behavior. On several occasions my horses have attacked dogs in my pasture , actually killing one who just turned belly-up and allowed horses to stomp it. I notified the folks running the tournament that if they gave me prior notice, I could put horses in Corral during the one day tournament. So far that has not happened.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
