I completely rebuilt a JD 7000 planter about 10 years ago. I pretty much took the planter completely apart, including the marker system and rebuilt or replaced every worn out planter part. The PO had used baling wire in some places if he could and some parts were put in backwards which can take time to figure out. I had bought an operators manual, dealership assembly manual, technical manual, service manual, and parts manual. Had to use them all to do a total rebuild. Added Yetter no till blades/down force springs and trash wheels. Got most of my parts and equipment from Shoup's. I also had issues with the monitor and the cables/sensors. Had to add new connectors and some sensors and replace some fuses and lights. Need to be sure the packer wheel rubber is good and check out the bearings. The packer wheel metal inserts will wallow out and allow them to wobble. I replaced or rebuilt every one of them to insure a good bed around the seed. Also rebuilt the transmission as most of the bushings and chains were wore out. Rebuilding the marker cylinder system is a good idea as it gets a lot of dirt and grease build up and won't cycle correctly. Took me a while to figure out how to remove and rebuild but the manuals helped out. Eventually sold it for a good profit. New owner loved as it worked like a new planter for a fraction of the cost. Makes for a great winter project. Good luck.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.