Posted by JerryS on January 18, 2016 at 15:53:52 from (98.80.110.211):
When I built a new house in 1996 I put down some 900 square feet of ¾ inch red oak tongue and groove flooring. It was my first and last flooring job. It served well for 16 years, but a couple of years ago I moved into another house that I had bought up the hill and allowed my daughter to move into this house. This change put into motion a “perfect storm” set of circumstances that led to what you see here. The daughter, in an effort to hold down her utilities cost, kept the thermostat set way low and she never burned the fireplace. Then last year we had rain after rain over several months; I got over 70 inches at my house in 2015. Some of the water ran under the house (up on piers) and remained there in small pools that never dried. Add to the fact that somehow the vent louvers on the skirting got closed, and the combined result was a ruined floor.
My daughter (who has recently moved to Houston) advised me last fall that there was a problem—a couple of the boards had buckled up. While I was pondering what to do, other sections of the floor in both the den and living room had exploded. Now I no idea what to do with this; probably I’ll just push it back down however I can and then put down carpet. (Heavy sigh.)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
