Posted by JD Seller on December 21, 2015 at 16:06:53 from (208.126.198.123):
Well I finally figured out what is wrong with the JD 239 motor with the CAV injection pump. I cleaned the complete inlet fuel system. I pressured tested for leaks. Everything checked out fine. I still had the trouble of the system sucking air when the engine RPMs where above 1500. So I installed a fuel pressure/vacuum gauge between the transfer pump and the filter. At low idle (500-600 RPM) I have 5-6 PSI which is within spec. At 1250 RPM I have 1 PSI and at 1400 RPM I have zero. At 1500RPM it pulls a vacuum on the fuel system. So I concluded that the injection pump might be the issue. So I took the return line off and put it into a measuring glass. At full throttle I have 1600 CC per minute of return. It should be under 750 CC. So there is an internal leak in the injection pump. So it is pulling more fuel than the transfer pump and inlet lines can provide.
So I get to take the injection pump off tomorrow. It will be fun!!! NOT!!! LOL This thing is rusted up from fertilizer. I am willing to bet that some of the injector lines will not come free. I am not sure that this pump can be rebuilt because of the corrosion. I am looking at a reman pump. The numbers on the pump are: Type: RE21504, DPA R3448F* ( Last digit not readable), Serial# 31817 KEG.
I know there are a few diesel pump rebuild guys on here. I would be interested in what they would have rebuilt/remaned. Shot me an email. I have been quoted $650 for a rebuild IF the housing/casing can be taken apart. It maybe too corroded.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
