Posted by Alan K on December 20, 2015 at 09:30:49 from (208.83.187.208):
In Reply to: tractor restore posted by stonerock on December 20, 2015 at 06:25:48:
Ive restored only one so far, back in 1986, a 1952 ZAU MM. I was missing a few of the extras that came with the tractor so I got in to making reproduction parts for them and haven't had the time to restore another one since then but am starting an M5 now. I wanted to get everything as close as possible back to the way it was from the factory, as in the operation of it. Getting what was mentioned below, the slop out of linkages and levers and the steering. It gives you a feel of what they were when new. You can do them somewhat cheaper if you know where to cut corners at and still come out with a good restoration. Ive seen a lot that were just a tractor on the farm with all the modifications done to it over the last 30 to 50 years with a coat of paint on it. The saddest thing Ive seen, which is just my opinion, is a tractor that is restored very well with a good paint job and the decals are either the wrong decals or in the wrong places. Some decal kits now days fit a few different years of the same model. People think all of the decals in the kit go on the tractor so they are put all over. With the power of google and tractor forums it wouldn't be that hard to find the correct info for them.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.