Posted by Blueboy on December 18, 2015 at 20:38:41 from (67.20.251.27):
I have a Detroit 3-53 in a Dynahoe backhoe that seems to have a fuel problem. This machine sat for about 15 years, the old fuel has been drained and filled with new. I put new filters, new fuel lines and everything else in the fuel system is good and clean.
My problem is I'm getting air bubbles in the return line out of the head. I've checked from the pump to the tank and there are no leaks. From the pump to the secondary filter there are no air bubbles that can be seen in a clear hose.
I was convinced it was a bad injector(s) leaking compression back into the fuel. But I was told by a friend of a friend (an expert) that would be impossible because the injector pressure is higher than cylinder compression.
Now I'm kind of stumped where the air bubbles are coming from. It gets worse as the engine gets to operating temperature.
I posted this on the Heavy Equipment Forum and there is a link to it at the bottom. It's 124 replies long but is a good read.
It has a YouTube link of the problem I'm having in post 57, 77, 89, 112.
What seems odd is when I pinch the return line the bubbles go away as seen in post 89 and 112
The guys on the Heavy Equipment Forum are awesome and helped me out big time! I didn't realize I had a fuel problem but they spotted it right away.
They suggested to run the rack and replace the injectors. I totally agree and plan to do so come spring time.
I'm posting here to see if someone can tell me exactly what's going on with these bubbles. Why they go away when I pinch the hose. And if there is anything we might have missed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
