Posted by leviskuse on November 30, 2015 at 07:01:22 from (198.110.57.2):
Hi people this is an update on a post from a while ago, about my Ford 4600 that i had the fuel pump turned up on and it drank the radiator in 5 minutes and stuff, anyways we tore down the engine and the head gasket was in great condition, the head block was not cracked no blocks were cracked, we pressure tested the system and we found that the block was porous, and that there was a cavity in the block, it had well water mixed in with full strength antifreeze to make 50/50 every time the coolant had been changed, for its whole life. we looked up from the oil pan into the block and the middle cylinder was the one with the little cavity in it, it was right between the liner and the block, the sleeves look SO thin from the bottom. if there are any it seems like they should be a whole lot thicker, but anyways yesterday my dad just told me that he remembered 10 years ago before i even started driving this tractor and before the fuel was even turned up, he had this same exact problem and he remembered he put this cheap sealer in the radiator to seal it from leaking into the block, and when we took the head off today , it looked like someone had put sealer in it before plus one of the coolant ports was plugged with this battery post corrosion type material, but the fact is , is i wonder if mabey 10 years later the seal just kind of broke or wiggled out of the cavity hole, but did that happen from to much fuel or something I DONT KNOW, but I'm thinking if i put new gaskets on it and put it all back together and buy some really good expensive sealer and try to reseal that back up. i would have to do a couple of oil changes to get all the coolant out that does leak into the block while i flush the sealer throughout the radiator "oh yea all crank bearings are good" . SO ANYWAYS, i think it was just a defect in the block, a bad block that came from the manufacturer , I don't know, but apparently this tractor had this problem before i even owned it. if it is possible, i would like the same people who were on my old post to post on this one too, too see what they think, AND all new people that see this post to.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
