Whew,it's morning. Not too sore from it all. We ran 63 5-700 pound calves through the chute yesterday. I pushed them through and did the castrating. The oldest boy ran the chute and scale,the wife gave the shots and poured them. We were done by 2 o'clock. No problem there if that had been it for the day,but there was a round bale feeder that was trashed,so I got that welded back together. When I took it back out,there were about 20 11-1200 pound fats headed out across the pasture. They aren't supposed to be there. They had smashed through a board fence at the end of the feedlot and were still pouring out of there. I slogged through mud that was half way to the top of my boots and dragged a gate shut so they couldn't get mixed in with the cows,but three of them already had. I shot back around front with the tractor,ran in the house and told the wife to call the boy and get him back here. While I was dragging a gate out to plug the hole,two more got out. We got the big group of them back around in the barn and in to the feedlot then had to go back out and sort off the ones that were with the cows. At the end,I was elated that I could still run and drag gates through the mud without my heart exploding right out of my chest.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.