Posted by rmorman on November 02, 2015 at 09:52:01 from (97.64.223.66):
Howdy all,
I had a thread started on a manual for my mower, but i feel that the next questions have outgrown that so I 'm starting anew. Long story short I'm getting a 340 and a No. 5 sickle mower going that has been in my family for at least 30 years. The tractor has not run much in the last 15-20 years, but has been stored inside. The mower had not been used much either in that same time period, but has been sitting outside.
Over the weekend I put a new battery in the tractor, checked all the fluids and got it running. That thing has always ran well. I hitched it to the sickle mower and Hotsy'd both of them off. Spent most of yesterday putting a new Hyd hose & pitman stick & on the mower, as well as greasing it. Hoping to test it out in the next week or so before the weather turns too cold.
Here is a picture taken JUST before I washed the pair:
I do have a couple of questions (Which will likely spawn even more questions):
QUESTION 1
Based on this picture, info from a friend & what I have been able to pick up in the Operators Manual is the rim size a 10-36 and the tire is a 12-36. Correct?
After talking to a good friend of mine he mentioned that finding that size tire would be impossible. The manual says that the tractor could have came with a 12.4x36. I figure that will fit on the 10-36 rim. This whole thing stems from the fact that one of the rims is soo badly rusted that it is seeping air. Hoping I can find a used rim and maybe reuse the tires. Colfax Tractor & Combine Parts is fairly close to me and after I gather some info I plan on contacting them.
QUESTION 2
Based on what is commonly available at a farm store/automotive store, what oil should I put in the sickle mower gear box?
QUESTION 3
This one might be a bit more complicated. As long as I can remember that tractor has had what I think is a peculiar Hyd problem. When sitting idle, the Hyd valve always sounds like it is "working." When you use the Hyd system, like raising the 2 point, the RPM raises slightly and the "working" noise lessens. The tractor seems "Happier." It seems like the hydraulics are fighting themselves when not being used and using them brings "relief" to the tractor. It has always been this way, but I was never sure why. Not sure if it is related, but the power steering is nearly a joke as well. You either have to be moving or rock the tractor back and forth to move the front wheels without lots of hyd squeeling and "catches" in the turning.
My current plan is to get these in good working order and then sell them to fund another project. So I'm looking to do this on a budget. One catch in that plan is that I'm beginning to enjoy tinkering on these again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
[/URL]
[/URL]
[/URL]