I always try to take Cash with me, never buy with anything else.
I showed up 1 1/2 hours away one time (was on my way home from farther away) to "last minute" look at this tractor. Guy was super nice, price was right, we hmmmm'd and haaaaa'd on it, and I finally told him I would do $400 on it (which was a fair deal in my opinion) I HAPPENED to have that much cash on me, just barely though!!! Paid the guy in FULL and left for home. Got home, hooked up the trailer, and was going to leave first thing in the morning.
Go inside, and there is a phone call from him. He says in the call "Yaa, so hey. I've been thinking about it, and I need to get at least $700 out of this thing, so, if you want to send me a check for $300 more, or bring cash with you when you come to get it, that would be great!"
Totally cool and collected though, like he had done it 1000 times! :/
Called the guy up, and told him we had 2 options,
1. I was coming down in the economy car to get my $400 TODAY or 2. I was coming down tomorrow with the truck to get the tractor, period.
He beat around the bush with me, and tried to get me to cough up $200 more, then only $100 more, then $50 more, and he finally said, well. okay.....
So, I went down there and got the thing!!! He wouldn't even talk to me when I was there, and when I was ready to leave tells me "I thought you were going to be a little more honest of a person..." I told him "Hey! WE shook on the deal, WE agreed on the price, and that is good enough to be "honest" in my opinion".
Some people are just that way, BUT, in this case, if it were me, I would have rather burned a bridge with a buyer, than with my family...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.