[quote="CVPost-Hoenes"](quoted from post at 07:01:12 10/29/15) I was told to always pour quick-crete around the hose clamp fittings, because even though they are stainless, they will eventually fail.[/
I still stand behind the, if you have the tools on the job do the whole line. The only time I just do a repair, is after I have ran the camera down the line to confirm no low spots holding waste, bad joints, root entry, or cracks in the pipe. And, that would be NEVER in old cast iron. It's bad in the section you have because it's run it's life span. It's done. Unless your planning to move soon, and stick the next person with the problem, do it right.
I don't want to be argumentative on someone else's suggestion, but here the fact on using concrete over a joint. 1) stainless steel band clamps are a code approved plumbing connection, concrete is not. 2) I have dug up plenty to find that when the concrete shrunk back, it left a path for a small root to creep in, grow large, and pop off the concrete. Then poor me, swearing now at the previous repairer, has to hammer off the concrete off to deal with it. In the case above, the joint would not have failed I guess, because the fernco joint would never have not failed. With being a licence plumbing business, we have to do things correctly because we got way to much to do, to do it twice. I highly agree the above that stressed compaction! If everybody laying pipe could have run a camera down a line to see the low spots holding waste from sh*tty workmen ship from no compaction would change their method of installation. Remember, It's a crappy job but some's has to do it. Heck of a retirement job from the nice clean office job I had.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
