EVEN IF SOMEONE OFFERS ONE FOR FREE, STAY AWAY FROM THEM!!!!!
The 2635 and smaller were made by TAFE in India. Tons of problems and high costs for parts. The engines are NOT Perkins. They are a Simpson, and the is no other source of parts except through TAFE! An MF service rep. told me of a 2615 in NC that was just out of warranty when the injection pump went bad. There are no parts available in America, Massey would not cover it, and no repair shop would touch it. A new injection pump is OVER $7500.00!
The HD series (2650 & up) were made in an MF plant in Brazil. MF no longer sources tractors for North America from this plant because the quality is so poor! At one time, the castings were taken from the molds, machined, and assembled without washing them out to "save time". You can probably figure out the results!
Oh, and the 3625, 3635, & 3645's built in Italy are even worse!
Look for a Coventry built Massey, or one of the new Iseki built units. Top notch quality on either of those. Even the Turkish built Uzel units were good!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
