Re: Farmall "C" govenor problem
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk ]
Posted by Jim Becker on September 04, 1998 at 21:39:53:
In Reply to: Farmall "C" govenor problem posted by Danny Boudreaux on August 21, 1998 at 21:30:46:
First make sure the linkage from the governor to the carburetor is adjusted right. Engine off, governor control wide open, throttle plate wide open; pin should just slide in without moving anything. If still a problem, remove the surge control completely and make sure the spring is clean and in good condition (not rusted away). Then you should be able to stop the surging by running the surge control in. Don't run it in any more than necessary to eliminate surge.
Follow Ups:
Post a Followup
|