Posted by JMOR on October 18, 2015 at 11:18:53 from (76.182.223.85):
JDSeller, I have had this question for a long time & have decided that you are likely to have a good answer for me if anyone does. This is an old Austin Industries/Austin Products, Inc., Dallas, TX (bough by Servis/Rhino in later years) 8 foot, dual spindle shredder/brush cutter. It has never cut very cleanly compared to three small 5 foot units that we use. I have tried many things: good sharp blades, setup with front an inch lower than rear (measured at blade tips, not housing), verified PTO speeds with PTO tachometer, even went so far as to swap gear boxes around so as to reverse rotation of spindles, all with virtually no significant improvement. Other observances: accounting for PTO speed, gear ratios, length of spindle-to blade-tip, this unit has a blade tip speed of 10,300 feet per minute @ 540 PTO rpm. The 3 other units blade tip speeds are, 10,700 fpm, 12,750 fpm, 16,300 fpm, and new SERVIS catalog cutters show 10,000-heavy brush, 15,000-standard, 16,500-finish. Khun hay mower-15,800 fpm. Of my three 5 foot units, even the 10,700 cuts easily two or three times cleaner than the 8 foot unit and the 16,300 very clean as you would expect, but can't even handle thick heavy grass behind an 8N. I have run the 8 foot behind both 44HP and 67HP tractors and at various ground speeds, all with nasty looking results over several years in different kinds of growth. Question is, do you have any ideas as to why this thing cuts so poorly? Potential remedies? Thanks, in advance for any experience/insight/etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
