Actually, they DO use anti-seize on many parts. Oxygen sensors are installed with anti-seize compounds on them. Any parts that use nickel alloys are also treated with anti-seize compounds.
Why don't they use it more? Well, its purpose is to prevent galling when using nickel bearing alloys. Since there are not a lot of nickel bearing alloys used in auto manufacture, use of anti-seize is of limited usefulness.
As to expense, the stuff simply is not that expensive as to be prohibitive for use in manufacture. While it may seem expensive to go to the store and buy a can of it, manufacturers buy their materials in bulk, and it is much less expensive that way.
Use of stainless alloys in automobiles is limited, and for good reason. Corrosion resistance is a primary reason for use of stainless, but there are disadvantages as well. Stainless is more expensive than standard non-stainless steels. Properties are another disadvantage. Stainless is softer than non-stainless steels. It does not hold an edge as well. It is prone to galling in fasteners. Lastly, stainless alloys are attacked by chlorides. Chlorides are the salts used on highways to melt snow and ice.
In this instance, there are a lot of good sound reasons for "why don't they...."
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.