You are so right. The same reason they don't use stainless bolts and nuts or brass/bronze where it would make removal easier like on exhaust parts. Costs and time.
The same reason I am dealing with a problem now. Our 2005 Camry needs new CV shafts. The older types have a castellated nut and cotter pin or nut with a stamped castellated cover and cotter pin. Now there is just a modified nut with a protrusion that has to be uncrimped from a groove to remove it. So no hole to drill or cotter pin to or slot to align at the factory. They just torque it and crimp the nut at the groove.
The problem arises with removal. None of the loaner sockets for the nut were the right size or were only 6 point. The nut has 12 points. I had to buy a deep socket at an outrageous price.
Fortunately the replacement shaft has a 6 point nut and they did have the right loaner socket.
So it has cost me several additional hours of lost time to save the manufacturers two minutes if that much plus my expense of a 12 point socket. Luckily I found one that was $14 and not $18-35.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.