You can still drive a Pinto. Here is the evolution:
Pinto car introduced in 1971. Goes through some minor cosmetic changes over the years, and by 1980 it is decked out with huge 5mph bumpers and an available V-6 engine. So, Ford throws a frame up under it, shortens the passenger compartment, adds a pickup bed, and the Ranger is born. Still basically a Pinto pickup truck. Same parts and running gear, still a Pinto, chapter and verse. Now, they put a roof over the pickup bed, add a rear seat, and now it is a Bronco II - STILL a Pinto, chapter and verse. Over the years, the 2-liter engine becomes a 2.3, the V-6 gets a few refinements like hydraulic lifters, timing chain (as opposed to gears), and a bit more displacement. One of the big shortcomings of the Bronco II is the lack of 2 more doors and a bit more engine. Upped the 2.9 to a 4.0 and added a couple of doors. The Explorer is born. The evolutionary path from the "lowly" Pinto is traceable back to 1971. To make it even better, the transmission used in the original Pinto was the C-3. The later Ranger, Bronco II, and Explorer used an extended version of that very transmission know as the A4LD and later the 4R44e, and finally the 5R55e. So, today, I still enjoy driving my Pinto SUV. Call it what you like, but I can trace the parts from modern Explorers, Rangers, and Aerostars, all the way back to the Pinto.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
