When I was growing up, we had an assortment of cars. Dad bought one GOOD car to get back and forth to work. After that, he got whatever he could get a good deal on. First recollection was a 1953 Pontiac followed by a 1958 Pontiac. Then came a 1962 Mercury Comet station wagon. Then there followed a line of various makes of used cars. Mother had a 1948 Chevrolet for many years followed by a 55 Ford Crown Vic convertible, a 55 Dodge Royal, and somewhere in between was a Studebaker. I also remember a 63 Buick somewhere in the mix. Once I started having my own cars, I was pretty much GM until somewhere in the mid 1970s. When I went to work for a Ford dealer, I saw how much better the work paid, how much easier it was to work on Fords, and that they were better built all the way through. From there on, I preferred Fords, but I had no problem with Chrysler cars either. I did own my share of them. Back in the 1970s and 1980s, I didn't much care about whatever the politics of the companies or their owners/founders were. The object was to get the most reliable car possible, since they ALL needed a LOT of maintenance back then. If it wasn't the semi-annual tune-up, it was shocks, mufflers, valve cover gaskets, or any combination of them. In that era, engines leaked, shocks had a short life, and exhaust started falling off no sooner than you put it on. Fords and Mopars were cheaper to run in those days. Then Chevrolet had their issues with cams, lifters, rocker arms, and pushrods. I only ever put ONE cam in a Ford. I got a bit of a bad taste for Chrysler cars over those K-cars. They were not the sturdiest. I like my Fords. They have served me well, and continue to do so on a daily basis.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.