And that's what the 2 gussets are for on top of the beam, when the cylinder is retracted and you do get a piece stuck,(I split everything and anything I can, including the gnarliest american elm it rarely happens) the gussets allow the wedge to free up.
The other thing I like about a wedge on the cylinder is that you can align it to the checks in the wood, especially with elm, and other kinds of wood its very helpful in making the splitting easier.
The debate or preference of wedge on beam or cylinder is age old, but this is a very good design, very similar to a Speeco/Huskee. A processor obviously needs the wedge on a beam. However, to make use of what a processor can't handle, one of these will split all the odd ball pieces, crotch wood and similar, every time if you know how to read the wood, I've never gotten anything stuck on mine that could not be pushed off or could not be made into firewood.
The old low rider types, like what Didier made, wedge on beam, there was no means to use the cylinder to push off a stuck piece, they are a real pain, I've split a fair amount on a friends over the years and get a piece of elm stuck on it, you'll work to get it free.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
