Dave is correct, Imagine a setting of .0005" (I know but go along with it) The cam lobe comes along and only the very tip of the lobe hits the rubbing block (very late, no dwell) If the point gap were .40, the cam would just get the points closed, and then they would open again (Early). Geometry. I agree that timing cannot be set by ear. In today's cars timing is however set by ""ear"". the knock sensor listens to the engine for the initial indications of spark knock (at a level so tiny we could never hear it) and sets the ignition timing algorithm to stay at that tiny knock level through operating range from running idle to full power from cold to full temp. The best we can do with a 1950ish tractor would be to apply a knock sensor, run the tractor under full load with the fuel of choice, and adjust the timing to just barely begin knock, and lock it down. Springs and weights would need to be tailored to meet the real world curve, but that is pretty high effort. Getting some advantage of today's fuels probably does allow more advance. But the timing still needs to be where it will start without backing up against starter rotation. Jim
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
