Loren, the Acg, I was telling my daughter about your wood processing equipment. What I am wondering is did you build everything needed to get the wood up and processed and hauled to the wood shed? My daughter has has been cutting on her 13 cord, and has it down to about 1 1/2 cord,that will have to be split and loaded on the one ton using the bobcat. We have been looking for a small elevator such as you have to load the one ton,hopefully we will find one, before the snow flies or next year. I am going to save your post to show my daughter such ingenious devices that you have for processing your wood. I am totally amazed at your process and the help that you get from your son and wife.
My son normally cuts both wood piles which keeps the family warm during the cold winter, we average between 10- 13 cord to heat the house. My daughter uses around 10, her house is extremely well insulated and she keeps it almost 80 degrees during the cold snap.
We have started with little fire at around 7:30 or 8 pm in the evening,using poplar wood saving the oak elm and maple for drastic cold spells. Again I want to compliment you on your system of making firewood, and wondering about how many years it took you to build that equipment? My compliments to you and yours, you have a wonderful family. Age and health issues keep me from such activity except my job is to operate the log splitter valve handle. My daughter is waiting to use the new one with electric start. My son built a volt meter holder so we can keep tabs on the battery being charged. Thanks again for your post,which gives us encouragement. Warmest regards, LOU & son
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
