Posted by RayP(MI) on September 20, 2015 at 18:33:34 from (207.241.143.27):
In Reply to: Re: ID This Farmall? posted by Bryce Frazier on September 20, 2015 at 16:48:13:
Two point hitch has a fixed width between the arms. Add an àdapter and you still have a fixed width. You may find yourself making mods to your equipment to fit. Most of the adaptions I had to make were longer pins and spacers behind them on the impliment to get the proper width. Many 3pt tools do not necessarily have a standard width between mounting pins. With a common 3pt width is not an issue because arms can move sideways On my Farmall 200, top link fixture bolted on in place of belt pulley housing. This then required a short top link. (Not commonly available.) Since linkage geometry is not standard, sometimes the impliment would flip up and out of place. Had to stop and move impliment back in place. That said, I used that system for several seasons before I could get a tractor with a real 3pt hitch. Soon's I can get 200 repaired it will be my hay raking tractor with a 3pt hayrake. Was a dandy setup.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.