That is why I am not too upset, equipment can always be replaced.
I was fighting with a lot of things today and got distracted, I know better.
I have the timing wheel looking real good now for the distributor, it only has about .001 runout, which is well within tolerance for the pickup coil. I have been fighting this starter for about a month, but do not want to put a new starter or drive on the bad ring gear. This starter really did a number on the ring gear. I changed the crappy looking starter out for the Threshers Reunion, and have had nothing but trouble with the spare one I painted. I have a spare flywheel and ring gear, so will put that on this winter when I fix the rear main seal leak. I will get a new starter then, so good ring gear and new starter should be good combination.
It is actually good that I am forced to put this away for the winter so I can get things ready for harvest. The dryer has a bad gas solenoid that needs replacing, and I have not inventoried the other issues.
I did look at the helical gear for the new hydraulic pump today. The pitch is correct so there is thrust on the pump, instead of trying to pull the gear off the shaft. I have to check the specs on the pump to see what the maximum thrust it will take. I will engineer a thrust bearing plate if it is not adequate. I did make a mistake on the flange for the pump. The hole is 3.5, and the pump is 3.25, so I will need to make a bushing for that. It is better too small than too big.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
