Posted by John in La on September 14, 2015 at 17:59:13 from (96.33.136.54):
In Reply to: John in LA posted by Russ from MN on September 14, 2015 at 06:02:58:
I talked it over with my son in law. We decided to replace the tank with one just like the old one since he had already bought the new tank; and we really did not want to pull the pump out of the well and remove the ball valve down in the well.
We removed the old tank. I spread and leveled 3 bags of concrete in a 4 foot by 4 foot area; and then put down 4 inch square concrete pavers. Installed the new tank using the old float and check valve. It seems to be working fine as is but I plan to go back in a few weeks and install a new check valve and float. We will then build a house to keep the weather off the tank. Since the pump is supposedly less than a year old this will give him a totally new system.
Seems like a pretty good system that you do not have to worry about rubber bladder busting.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.