Posted by Geo-TH,In on September 10, 2015 at 09:34:02 from (172.78.72.128):
Hoping JD Seller will weigh in on my leaky hydrostatic. I purchases this tractor used a few years ago. I think it's a 1997. Got it because it has a 30 inch tiller and 48 inch mower which I use mower for trim work. The hydrostatic rear end has been leaving oil on barn floor and getting worst. It cooled down a little, so I took it apart yesterday, oil all over the place. I cleaned it, filled it with oil. It sat over night and not a drop of oil. I put it back in tractor, removed tires, pushed on clutch peddle so the rear wheels were moving and ran it wide open for an hour, not a drop. As you may notice, I used a high tech leak detector, paper shop rags packed in every place I thought it could leak. All were dry.
It would leak a good ounce or more after 30 minutes of use. So why no leaks? The only thing different is it's not bouncing around in the yard, it sitting on the concrete pad. Is it possible my problems is with the vent on top of the hydrostatic and oil was splashing out? I hope so, but my luck it will start leaking now it's back together.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.