Posted by buickanddeere on September 07, 2015 at 19:02:49 from (216.183.158.168):
On a roll around here . I guess the Yellow jacket stings while working on the Sabbath wasn't enough. My kid was driving the tractor as we were pruning apple trees. There was a sudden shout and he was running around the tractor all in a dither. A vengeful tree branch caught a valve stem breaking it off and allowing the liquid ballast to spray out of the tire. Told the kid that maybe he should not be panicking and drive up to the shop before the tire goes flat. He did but not before driving into a rock that I had previously warned him about.
Got to the shop and the floor jack was still under the other kids pulling tractor even through I had told him 3 times to put the d*mmed tires back on. Instead of starting several jobs and only getting some of them 1/2 done. Pulled the floor jack out anyways and let his tractor land on the floor. Put the jack under the leaking tractor before the tube became pinched.
Most of the inner stem is broken off but I was able to make about five good 1/8" pipe threads inside the remainder. Threaded in a spare outer stem and inflated for an over night leak test.
This post was edited by buickanddeere at 19:20:34 09/07/15 2 times.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.