Posted by Bill VA on September 02, 2015 at 04:34:34 from (76.3.243.86):
Had the mother load of lime brought in and spread on my hay fields. Big truck with spreader on back. Being broadcast, the application is somewhat streaky, heavier concentration centered behind the truck and lightens up as the distance from the truck throws - as expected. To counter this, the driver overlapped the edges to achieve some evenness. However still somewhat streaky.
This lime was like fine powder, no real granuals - almost like baby powder. The driver did a good job IMHO, but not sure broadcasting this stuff is the most efficient/even spreading that can be done. But it is practical and I got what every farmer the coop puts down for everyone else.
Maintaining the PH. We are making hay and once we get our PH up to snuff, I don't see anymore "mother loads" but maintenance sized loads.
Just curious of how often you reapply lime and in what tonnage per acre in your hay field?
With maintenance application, what is the pros/cons of using an old drop spreader (with provisions on the auger)) to put down lime. I think I can put down lime at a lower cost if I can do it myself and with a drop spreader, I'd have what I think a more even/measurable application.
12-13 acres today, up to 30ish in a few years.
Back on the day, when all the farmer had was a drop spreader, how did they make out?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.