Posted by Goose on August 20, 2015 at 19:39:10 from (70.198.8.64):
We have a Poulan garden tractor with a 24 hp B&S engine. 320 hours on the meter. We don't use it to mow as much since we got a zero turn but it's still handy to have around.
Anyway, about a year ago a pushrod bent. I took the pushrod out and straightened it. Then I figured out the rear steel brake line on a Chevy pickup parts vehicle was a perfect press fit over the pushrod. I cut a piece of the brake tube about an inch shorter than the push rod and pushed the brake tube over the pushrod with about a half inch on each end. While reinstalling the push rod, I found the valve was stuck and I had to tap on the rocker arm to free the valve. Put it together and it ran fine-until today when it did the same thing with a different valve and pushrod.
I did my same bit with the piece of brake tubing. Then I figured while I had it apart, I might as well reinforce the other two pushrods for insurance. Found one of them with a slight bow in it. That one must be a slightly larger diameter than the first two 'cause the brake tube would not push over it. I straightened that one and put the whole works back together. It's running fine, now, for the time being. I just ordered two new pushrods online. I'll see what they look like.
Is this a known problem with the Briggs OHV engines? We had a 20 hp that went over 900 hours before we got rid of it and never had this problem. What would cause the valves to stick? Carbon on the stem?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.