Posted by Steve@Advance on August 16, 2015 at 16:59:35 from (107.203.134.67):
In Reply to: CV Half shaft posted by John in La on August 16, 2015 at 16:33:53:
Not sure of that exact model, but generally not too difficult. It involves disconnecting the lower ball joint, removing the big nut in the center of the hub, pushing the splined shaft out of the hub while swinging the strut assy out. Then the other end pops out of the transmission, comes out with a prybar.
Sometimes the spline shaft needs to be pushed out of the hub with a puller, which can be borrowed or rented.
Best option I have found is to buy a reconditioned half shaft. Trying to get a new boot to stay on and get it clamped properly is near impossible.
But... I'm just giving generalities here, could be completely off base for that particular model. Might look on Youtube or get a manual.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.