Posted by Fatjay on August 16, 2015 at 09:21:25 from (108.2.123.206):
I'm goign to be putting in a pole barn but after reading some other posts, realized I have some questions.
My plan was to keep it cheap, cinder blocks for the perimeter, 14' poles 4' into the ground, packed gravel floor with maybe some plywood down. Was going to go sliding on the front, vertical doors on the side.
Overall size will be approximately 20x40, but due to space constraints it will be tapered, so 25' on one end, 15' on the other. Just tall enough to get 4-5 tractors in. Workshop is seperate, a 12x24' that is about 15' away.
I'd love some advice, I was just planning it as I go. Concrete base is not in the budget at the moment
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.