Ryder and Hertz Ford trucks, some of U-hauls have a tranny equipment package that keeps them going in abusive conditions. External oil cooler is one thing, same thermostatic fan as used on radiators in some of the small cars--and a external oil filter inline with the cooler lines. Standard large Ford truck filter that gets changed about every other engine oil change. The tranny oil capacity compared to standard is about a extra 1/2 gallon or so, fresh tranny fluid needed added every filter change so level is monitored much more than many units get in private use and some commercial use with new drivers every couple months and especially with rental units. The package does take up some space in engine bay and by side rails so vans and trucks are about the only units having them- the old Crown Vics used by some police units had the external filter and a small external cooler inline tucked in tight close to beloww bumper air intake slots and some of the cab companies keep them when they get the police surplus units. commercial service recommendations for tranny oil change and tranny filter at 25,000 miles would be overlooked after first change under warrantee with old 'internal' tranny filters- the added external filter getting a change at 10,000 miles gets a lot of the crud that can cause added wear on plates and some seal rubbing wear. After market install is about $200.00 on parts wholesale, order the package with new truck or van from dealer to be installed at assembly plant and cost is about $300.00 added to delivered price- those prices a couple years old and likely have gone up for the 'commercial/rental' package. The after market filter adapter was about $89.95 retail with some discounts from Rock Auto getting it to about $50.00. RN.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
