MarkB_MI said: (quoted from post at 05:35:20 07/30/15) A little selective editing, Cooter.
91.119c actually says "An altitude of 500 feet above the surface, except over open water or sparsely populated areas..." Given that the vast majority of the US land mass could be considered "sparsely populated", that's a pretty big loophole. The FAR doesn't define "sparsely populated", so I've always interpreted it to mean "anywhere you're not likely to violate the 500 foot separation requirement if you descend below 500 ft AGL". Which gets back to my point that the real requirement is to maintain 500 feet between your plane and any buildings, vehicles or people.
Regardless of how you want to parse FAR 91.119, I think we can both agree it doesn't confer any sort of "ownership" of airspace above one's property.
Not to belabor the point but you said no such rule exists, which it does. There are exceptionswhich I pointed out. The rule would broadly apply east of the Mississippi. Sparsely populated would refer to areas that resemble open water, like the desert out west or the Appalachians in the east. Those areas are pretty recognizable from above. Where I live in Missouri, although rural, wouldn't apply. Sparsely populated is the exception, not the rule.
This post was edited by Cooter143 at 06:42:12 07/30/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.