Posted by JerryS on July 15, 2015 at 12:14:22 from (98.80.98.245):
How would you go about extricating 80 grown cattle from a double-decker livestock hauler that has been flipped on its side with the rear doors jammed? That's the dilemma local authorities (Shreveport) faced yesterday when a lost driver tried to make a turnaround out of a store parking lot and cut too short. He was hauling the cattle from a nearby ranch, enroute to Colorado. He was only a quarter-mile short of his link-up with an interstate; why he exited from a major state highway onto a parallel service road in a busy commercial area is unknown to me; he's probably now wondering the same thing too.
The incident shut down the major highway and the service road for most of the day while police, sheriff's deputies (including the Sheriff's livestock patrol unit) and firemen worked to straighten out the mess. To me, looking at it from a distance, the logistics of the thing seemed mind-boggling: where do you quickly find enough wranglers, trailers and equipment to attack this problem?
Apparently they figured it out. They used jaws-of-life gear to open holes in the trailer. How they got the individual cattle out and into waiting gooseneck trailers, I don't know. The fire department, in addition to loaning their jaws, kept the cattle cooled with a spray of water throughout the ordeal. I understand that 24 cattle were killed in the wreck or put down. I wish I could provide more details but my local newspaper has this philosophy that if the TV cameras cover an event prior to their press time, the event never happened or was unworthy of their attention; "tree falls in the forest" sort of reasoning.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
