Posted by The tractor vet on July 07, 2015 at 17:00:07 from (104.179.81.68):
In Reply to: moving a cornpicker posted by Nick167 on July 07, 2015 at 16:15:59:
I have moved loaded and handled many New Idea mounted pickers and hauled them three hundred to five hundred miles . If this is what your looking at then to move it first ya need to wedge in a 4x4 between the two gear boxes to keep it from squashing together . Ya need a loader with a boom pole about six to seven feet long to keep it away from the loader and you use a chain to down around the frame work next to the gear boxes that run the gathering chains. . Then ya load the husking bed with the elevator facing the ft. of the gathering unit and chain it down the best ya can by hooking to the solid parts . Or ya buy a tractor and put it on the tractor mount the picker and remove the elevator and drive it on the trailer being vary carefull not to drive off the side of the trailer . Once on then ya stuff the elevator up under and throw a couple straps across it . So you don't want that tractor then ya dismount the picker and sell the TRANSPROT tractor and put the picker on what you want. Did that twice to get a picker out of a sale.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.