Posted by MarkB_MI on June 25, 2015 at 02:15:29 from (70.194.30.91):
In Reply to: Why not metric ??? posted by da.bees on June 24, 2015 at 20:17:02:
Basically, it was a lack of will. As with everything, when faced with making a difficult change that's best in the long run versus doing nothing, most folks will opt to do nothing. Making the switch to metric is just a macro version of going on a diet or saving for retirement: it takes will more than desire to make a change. The will of state and federal governments to push metrification simply isn't there, and in the current political climate it isn't going to happen.
The only place where metrification has succeeded is in those industries where the need to produce and sell products outside the US outweighs the desire to placate US customers. Which is why the auto industry is pretty much 100 percent metric. Interestingly, though, nearly all cars, regardless of the country of manufacture, use 7/16 bolts for the seat belt anchors; apparently that's the only fastener that meets federal safety standards.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.