Posted by IAtractorKid on June 15, 2015 at 17:30:32 from (184.97.38.234):
Hey guys! So I'm getting ready to build a 40x60 pole barn with a 24x40 concrete approach in front. Had a couple guys come out to give me quotes on leveling a pad...I live just over the top of a hill.
First guy is a friend and seems very knowledgeable, doesn't think I would be happy digging into the hillside and would rather haul dirt in. His opinion is that digging into the hillside will take up almost my entire yard by the time he finishes everything back out. He figures it will take roughly 52 loads (18 ton loads) of dirt to build the pad up. Yikes!
Second guy (older guy...kinda grouchy but seems knowledgeable as well and has more experience) thinks it would be rediculous to haul in that much dirt and wants to dig into the hillside. Don't know if he gave any consideration to how much yard I would have left though and he didn't mention anything about drainage.
I don't have the quotes back yet but would guess the second guy is going to be ALOT cheaper. Initially my plan was to dig into the hill, but now after talking to them and really looking/thinking myself, I think would rather have the dirt hauled in...
What do you guys think? What would you do in my position? Is one way better than the other?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
