Not hijacking your thread, but on your 235 OHV I6, back when I was a teen, a lot of badmouthing was going around the Ford circuits about Chevys and their Babbit bearings....Mains and rods.
Well, in my quest for information associated with my current off time hobby, I got the Wikipedia on the subject of these engines including the Jimmy 270 which was popular with a split exhaust manifold and dual glass pack mufflers and pipes.
Anyway I know that rod and main bearings are copper with a layer of "Babbit" but the distinction between what we do with the metal today, and Ford and others apparently did back then, was to put it in a removable shim.....the insert, whereas GM cast it into the engine block and cap for mains or rod bearing surface for connecting rods. This required a shim, copper as I recall, to be inserted between the crank and rod if wear wore the gap out of acceptable tolerance.....had heard of people using shoe tongue leather for the purpose.
Anyhew I learned something. Another thing I learned was that the I6 was an inherently balanced and smoothest engine design without special tweaking to neutralize the natural occurring harmonics. Said it was one reason for it's popularity. If you have time and are curious, lot of great info online at that site.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.