Posted by JDNewbie on June 10, 2015 at 15:35:50 from (24.255.197.99):
I'll add one more gripe to the way people are driving these days...
When I took Driver's Ed some 20+ years ago, I'm pretty sure I remember learning one is to pull to the right and come to a complete stop when an emergency vehicle approaches with its lights and siren going. I wonder if that is still the case?
Yesterday. Four lane road without a median, just a yellow line. Ambulance is in oncoming traffic with siren and lights. I pull over to the right and stop. I saw the ambulance coming quite a bit ahead of me, so I didn't stop immediately, but the ambulance was probably a city block out in front of me headed towards me when I stopped. I was driving a mid-sized car, so it wasn't like I was in a great big truck that people couldn't see around me. At least 3 people passed me and kept right on driving! I guess they were in a bigger hurry than the ambulance!
I know it was four lanes, but I understand the rule to be the same and I have had folks pass me on a two lane road in the same situation. I don't pull over and stop on a divided 4 lane road (like the interstate with a median) in the same situation. Am I wrong?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.