Hey Jeff, I'm honestly not much of a tractor guy, but I spotted this thread and had hoped I could get some info. I just picked this Emglo D8HGA-30P up on CL for $100. A fair deal I'd say. But now I need to complete this compressor. I'd like to make this an electrically powered unit for use around my house/shop. It had an 8hp Honda, but I would like to know what they equipped it's electrically powered equivalent with from the factory. Since you said you reped for the Co. I'm hoping you might know. The guy that sold it to me said it's about 10 years old and was in service for about three years where he worked at National Grid before someone lifted the engine off it from out of the shop. His boss told him he could just take it and though he intended to do something with it, he never did and thus it's been sitting ever since. I gather you're a fan of the pump if nothing else, I thought it was a 2 stage until I saw it up close, I have to admit that I was a big disappointment. According to Jenny it can do 16.2 CFM @ 100 PSI and 15.6 CFM @ 125 PSI and that's not half bad, but that's with the Honda 8hp. Anything you got I'd appreciate. Thanks, Danny
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
