Posted by IA ROY on May 19, 2015 at 11:03:42 from (24.149.10.69):
I got a car in January. Saturday I decided to see if I could get the wheels off, correct jack, and wrench etc. I found the first one, I could not get one nut off. I got out the impact wrench and still had to work it back and forth and finally had to pull it off with a vise grips. The threads had galled and were destroyed. I then had to use a dead blow hammer to pound it off the hub. Corrosion between aluminum wheel and cast hub and full of gravel dust. The rest of the lug nuts came off, but still had to pound the wheels to get them off. I put anti-sieze compound between the wheel pilot diameter and the hug. I cleaned the studs, lubricated them and then washed them off with carburetor cleaner. I had been told not to lubricate the threads as it can lead to over tightening even with a torque wrench as you get them a lot tighter than with dry threads. What is the proper way to do this? The lug nuts have tin covers on them to try to keep clean, but evidently didn't do the job.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.