Posted by 2510Paul on May 01, 2015 at 13:30:03 from (173.202.142.245):
In Reply to: Re: 2510paul question posted by deerejockey on April 30, 2015 at 20:54:43:
Yes, if you need anything please let me know. It would be easy to get you sizes of the main items. As I recall there were three overriding goals I had.
1. The beam between the front loader bracket and the axle had to be neutral, that is, no torque on the front loader frame as a result of the beam bolting to the axle when the loader is unloaded. I hope this made sense.
2. I did not want any welds at the point where the beam passes under the rear of the front loader bracket. I was concerned varying and shock loads on the loader, e.g. round bales and running over rough ground, would crack the welds over time. As you can see I used a very large angle and bolted it.
3. And it can all be put back to original if desired.
So far it has worked. After several years or hauling/loading/unloading round bales it all has held together.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.