If you'll be going off pavement, go with a rough terrain model. They will work on both surfaces The low profile, solid tire models will not go off pavement. Even uneven surfaces, like tapered thresholds, ramps etc, give them fits!
Size the lift to the size of your shop. A 2500-3000lb model is much more maneuverable than a 5000lb. Unless you really need the extra lift capacity, go small for a small shop. The small lifts are harder to find. People tend to hang on to them longer.
My preference would be a propane model, gas 2nd, electric 3rd, diesel last unless you can leave the door open or use it mostly outdoors. But the real determining factor would be what I can find, afford, and what condition it is in.
Things to look for, just like any other piece of equipment... Outward appearance means little. Be equally weary of "steam clean and spray paint" rebuilds! Oil leaks are the typical indicator of condition, weather they be hydraulics or drive train, if it's leaving an oil trail, it will soon need repair. But then, sounds like you will be only using it occasionally, and likely you will be the only operator, so no need spending $7000 when $1500 will do you well for many years.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.