Jason S., In our Burgess Seed & Plant 2015 Spring catalog page, 44 they list Burbank Russets and a host of other type potato. For the list under the Burbank they list them by number of seed potato,ie 20- 40- 80- 160 seed potato's cost for as follows 20/ 4.99- 40/ 9.49- 80/ 18.49- 160/ 34.99. We haven't ordered them from Burgess, we have a local farmer who sell them to anyone name Klinger Farms, in Chippewa Falls,Wi. We haven't had to buy for a few years,we have excess from last years picking that turn to seed for us and we just replant them next year. I don't think it has to do with a regional thing,but more of what the sellers think they can get rid of for popularity of spud.As long as you follow the fertilizer and watering requirements along with the spray for bugs and diseases that each potato has you will be fine. They save almost a year for us (Burbank russets) and make very good fries and baked,along with whatever we desire at the time. Orida used to buy from the farmer we used to drive for,Orida became too picky and specified what equipment and break area size the farmer had to have,so he quit. Talked to another big potato grower and according to him, Orida told the farmer to plant them and at the harvest time orida would tell the farmer what they would pay for them. He quit and went to soy beans and corn. Hope the info helps. LOU
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.