Posted by super99 on April 17, 2015 at 19:53:37 from (74.32.246.77):
I bought a new Outback S lite guidance set up for my 1850 to spray burndown on cover crop rye. I thought I had it figured out, but I was wrong. I had it set and made the perimeter pass OK. I went around the field 2 times so I would have plenty of room to turn and find the signal before I turned the sprayer on. You are supposed to be able to switch from contour to straight line mode on the go. I started out after 2 passes around the field and switched to straight line mode and the light to drive by went out leaving me lost. I had pressed enter for A , probably forgot to push enter to set B at the end of the pass. It had me wandering all over, so I switched back to contour. I have the sensitivity set on medium, but as I go across the field, the center light goes out and either the red or green light comes on and as I try to get back in line, all the light go out for a second or 3 and then the lights start on one side of the arc and go clear across to the other side, eventually the center light comes back on. I think there will be several missed spots when the rye finally dies. Towards the end I wasn't looking where I was driving, I was glued to the center light trying to keep it on, I had been hearing a loud banging, the field was pretty rough, so I just figured the sprayer was bouncing around. I finally looked at the pressure guage and it's on 0. Stopped and look back and down, the back 1/2 of the PTO shaft is gone and the front 1/2 is banging around on the drawbar. Looks like a good time to quit since it's almost dark. I'm not sure if it will save the info if I turn it off, so I left it on . I'll have to take the pickup and drive around the field in the morning to find the PTO shaft and then try again. Man, if this wasn't so much fun, I'd just quit altogether!!! Chris
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
