I've spent all week trying to remedy the destructive actions of the grease worms that had swarmed a customers machine. Seems they had eaten the bushings nearly all the way out of several joints (that I have found so far) and began feeding on the surrounding parts.
To that end I spend the week getting things torn down, and parts ordered. This weekend I get to begin repair the elongated holes in both ends of a 9" diameter tilt cylinder, and hope to get done with both of them. Monday I'll probably get the machine pressure washed so I can weld the eyes on the machine up without it catching fire, and get everything ready to line bore another day.
The fun part will be telling the customer we need still more pins and bushings for the attachment.
It's amazing, you give the guys good grease, and they still don't use it like they should, only use it when it's convenient for them (on places easily accessible, or where they won't get dirty), or even worse don't use it at all. They got the good grease over a year ago, and I have yet to see any of it on any of the pins I've pulled. Given the situation, I'd almost bet somebody gets fired, or at least gets sent home without pay for a few days, over this ordeal.
On top of this, they have run over so much crap and broken the solid tires down so far in a year, that the rears are now 6 inches larger in diameter than the front, and the right front is another 3 inches shorter than the left front. This means the machine is fighting itself front to rear, causing wear and tear on the transmission. Then it's also fighting itself side to side, putting a strain on the differentials, as well as the center pivot.
In the end, I speak my mind, but learned long ago to view the whole mess as JOB SECURITY......LOL
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
